Bland to Grand: Jaw-Dropping Before and After Kitchen Island Makeover

This rather boring island needs a before and after kitchen island makeover, let’s see what we can do. 

Before and After Kitchen Island Makeover

Here is the island before with just a lighting textured painted drywall. 

Before Unsupported Counter

One of the biggest issues was the granite hanging over an edge without anything to hold it up.  It seemed stable and anchored well, but visually it was not working.  It felt unfinished and needed an update.

Sketch Out the Plan

Sketching out a plan helps to know if you will like what the update will look like.  In this case, the client did not like the addition of the X in the panel, like we had on this farmhouse Dutch door project.  So we left that out of the actual build.

Install the Beadboard

First, measure where the edges of the vertical corner boards will be and center the beadboard grooves in that space.  These small details really help the project look right when it is done. Then nail on the beadboard.

Install the Boards

Now install the board and batten treatment.  Start with the corner boards of the middle section.  

Install Vertical Batten Pieces

Next nail on the horizontal boards on top and bottom, in-between the corners. Then the vertical dividers spaced evenly. You may notice that the bottom of the board and batten is not on the ground.  The plan is to wrap the entire island in base molding over that gap.

Wrap Edges with Molding

Wrap the whole corner with wood to create a really clean finished end. 

Fill Any Gaps

Fill gaps with left over MDF pieces.  This makes a place to nail in the bottom of the base molding. 

Install Base Molding

Here is a shot of the island with all of the molding in place.

Caulk and Patch

Be sure to take the time to caulk the 1×4’s to the beadboard.   This gives it a nice professional clean look after it is painted. If you need there is a a  great caulking tutorial here.

Pre-Drill Holes

The corbels will need a little bit of prep before they can be installed.  Pre-drill two holes on top and two on bottom to screw the corbels to the kitchen island.

Notch Back of Corbel

With this island’s shape, there are two 22.5 degree corners that are going to get a corbel.  In order to install the corbel they needed to be notched out on the table saw.

Attach Corbels

Install the corbels.  In addition to the screws, feel free to use a small amount of adhesive. 

Plug Screw Holes

After they are screwed in place use the plugs to fill the screw holes.   

Fill, Sand and Paint

Cut the plugs flush with a multi-tool, then patch, and sand til smooth. Finish up any painting and you are set. 

Final Kitchen View

Here is the kitchen island makeover with everything finished.  It looks so much more grand and is a great focal point for the room!  And the big bar now it makes a lot more sense that the corbels are there holding up the heavy granite.

Countertop Detail

Find the full tutorial with step by step instructions for the full kitchen island makeover here.

Reader Makeover:

We’ve had many people try out the tutorial with great success. 

You Might Also Like:

 Reclaimed Wood Kitchen Island Tutorial

Try This Project:

DIY Modern Concrete  waterfall countertop

Try This Project

Upcycled Dresser into Colorful Kitchen Island